Examine the blades. Which one is misaligned? (Look from the side. One blade should sit exactly on top of the other. If one is higher, that’s the misaligned one.)
Insert the tip of another clipper (or your tool) into the hole of the misaligned clipper.
Gently apply pressure in the opposite direction of the misalignment. For example, if the top blade is bent upward, push down.
Make small adjustments. Bend a little, then test. Repeat until the blades align.
Clean the clipper with rubbing alcohol after adjusting.
When to replace instead of fix: If the blade is bent severely, cracked, or if the pivot pin is loose, replace the clipper. A poorly repaired clipper can cut unevenly or injure you.
How to Clean Your Nail Clipper (Using the Hole)
The hole can help with cleaning, but here’s the full method.
What You’ll Need:
Rubbing alcohol (70% or higher)
Cotton swabs How-To,DIY & Expert Content
Toothpick or paperclip
Small brush (an old toothbrush works)
Steps:
Soak a cotton swab in rubbing alcohol. Wipe down both blades, the lever, and the pivot pin.
Use a toothpick or paperclip to scrape debris from between the blades. Insert the paperclip into the hole to stabilize the clipper while you scrape.
Dip the small brush in alcohol and scrub the crevices.
Rinse with water (if the clipper is rust-resistant). Dry thoroughly.
Hang the clipper by the hole to air dry.
How often: After every use (quick wipe) and deep clean monthly.
A Brief History of the Nail Clipper (And That Hole)
The modern nail clipper was patented in 1875 by Valentine Fogerty, though similar tools existed before. The design has changed surprisingly little in 150 years.
Early clippers were often made of cast iron or steel. They were heavy, prone to rust, and expensive. The hole served a practical purpose: hanging the clipper on a nail in the workshop or bathroom.
As manufacturing techniques improved, clippers became smaller, lighter, and more affordable. The hole persisted—not because it was essential for hanging, but because it served the secondary purpose of blade alignment. Dictionaries& Encyclopedias
Today, most clippers still have the hole, even though many people never use it. It’s a design feature that has outlived its original necessity but remains useful for those who know about it.
Frequently Asked Questions
Can I use the hole to sharpen my nail clipper?
